 |
|
|
CONREPO |
|
|
| This MX Add-in
generates an output file of string points from a specified model. This
report is commonly used to provide 3 dimensional string information to non-MX
consultants.
The resulting data is formatted with one point per line. Each line contains the string label, easting, northing and elevation. Output for PSDR strings also includes the survey shot numbers. Output for PSSA strings also includes the survey traverse stations. ConRepo is not designed to output triangulation or geometry strings. |
|
|
| From the MX
Add-In menu, select Personal Add-Ins => ConRepo. If
the ConRepo Add-In is not available, then refer to MX Add-In Index
for directions on installing an MX Add-In.
Before the ConRepo Add-In can start, you are
required to accept the NHDOT disclaimer. |
|
|
At the top of the Text report of model panel, select the String Model Name that is to be reported. Next, click on Select Output File to direct the output to a file and location. At the bottom of the Text report of model panel is the Output All Strings check box. If this box is left checked, then all the strings in the selected model (with the possible exception of the PSDR string) will be output. To exclude the PSDR string, uncheck the Output PSDR check box. Since the PSDR string is a duplicate of every point in the model, it is recommended to uncheck this box if file size is a concern. Should the non-MX consultant require the survey shot numbers held by the PSDR string, then leave this box checked. If it is desired to further limit the strings
that are to be reported, then uncheck the Output All Strings check
box. This will update the Text report of model panel with a list
of available strings. Double-click on a string label to remove it from
the list. Repeat as necessary. All remaining strings on this list
will be output. |
|
|
|
To generate the report, select OK. Until further notice, avoid the Apply button. Examples of typical output is as follows:
|
|
CAD/D Homepage
| MicroStation v8 Documentation |
|
|
