Smaller text size Reset text size Larger text size
skip navigation
NHDOT Home CAD/D Home MicroStation MX v8i OpenRoads Downloads
CAD/D Home > MicroStation > MX to MicroStation v8i FAQ

MX to MicroStation v8i FAQ

This section of the documentation is created from user questions and problems.  It should be consulted before calling with a problem.

back arrowBack

No graphics appear after attempting an MX transfer to MicroStation.  
Items are not landing on the correct levels in MicroStation
.



No graphics appear after attempting an MX transfer to MicroStation.

If the MX transfer to MicroStation is unsucessful, check the project directory for a file with the project name followed by a .MSS extension.  If this file does not exist, see a member of the CAD/D support staff before continuing this procedure. If it does exist, open the file with PFE or Notepad to make sure it is correct.  It should look something like this:


Metric Imperial
[SEED_FILES]
MX_MODEL_SEED=nhseedm2.dgn
MX_DRAWING_SEED=nhseedm2.dgn
MX_CELLSEED=exist-in.cel
[SEED_FILES]
MX_MODEL_SEED=nhseedf2.dgn
MX_DRAWING_SEED=nhseedf2.dgn
MX_CELLSEED=exist-in.cel

Any references to mx_seed_m.dgn or mx_seed_ft.dgn need to be corrected.

There is also a suspicion that the length of the drawing file's address and/or file name can influence a successful transfer.  When all else fails, try shortening the Drawing Picture File name or try to transfer at a higher folder level.

back arrowBack

Items are not landing on the correct levels in MicroStation

This usually means that the MX model defaults for the model being drawn need to be adjusted.  If the style and feature sets listed in the model defaults do not match the data in the dpw/dpf, then the elements will not be placed on the correct MicroStation level.

While in MX, select Model Defaults... from the Tools menu.

model defaults

Select the model being drawn.  The style set should be set to the one used to create the drawing.  The feature set name should match the style set's name.  See Style Sets to verify the appropriate style and feature sets.  Click the Edit... button to modify the sets.

model defaults

From the Edit Model Style and Feature Set panel, check the box labeled Lock Style and Feature Set if it isn't already checked.  Then select the 3 dot button button next to the style set name to choose a different style set.  The feature set should update automatically when the style set is revised.  Click OK to save this information.

Redraw the model in MX and transfer again.  If this does not resolve the problem, contact the CAD/D support staff.  It is also possible that there is a discrepancy between level information in the style and feature sets.


Related Pages

MX FAQ

MicroStation FAQ





New Hampshire Department of Transportation
PO Box 483 | 7 Hazen Drive | Concord, NH | 03302-0483
Tel: 603.271.3734 | Fax: 603.271.3914

copyright 2014. State of New Hampshire